beautypg.com

Breakd own assista nce, Towing and tow-starting – Mercedes-Benz SLK-Class 2013 Owners Manual User Manual

Page 304

background image

Installing/removing the towing eye

Installing the towing eye

G

WARNING

The exhaust tail pipe may be hot. You could

burn yourself if you touch the tail pipe. Be

particularly careful when removing the rear

cover.

The mountings for the removable towing eyes

are located in the bumpers. They are at the

front and at the rear, under the covers.

X

Press the mark on cover : inwards in the

direction of the arrow.

X

Take cover : off the opening.

X

Remove the towing eye from the vehicle

tool kit (

Y

page 291).

X

Screw the towing eye in clockwise to the

stop and tighten it.

Removing the towing eye

X

Loosen the towing eye and unscrew it.

X

Attach cover : to the bumper and press

until it engages.

X

Place the towing eye in the vehicle tool kit.

Towing the vehicle with the rear axle

raised

!

The ignition must be switched off if you

are towing the vehicle with the rear axle

raised. Intervention by ESP

®

could

otherwise damage the brake system.

X

Switch on the hazard warning lamps

(

Y

page 109).

X

Turn the SmartKey to position 0 in the

ignition lock and remove the SmartKey

from the ignition lock.

X

When leaving the vehicle, take the

SmartKey or the KEYLESS-GO key with you.

When towing your vehicle with the rear axle

raised, it is important that you observe the

safety instructions (

Y

page 301).

Towing a vehicle with both axles on

the ground

G

WARNING

The power assistance for the steering and the

brake force booster do not work when the

engine is not running. You will then need

much more effort to brake and steer the

vehicle. Adapt your style of driving

accordingly.

X

Switch on the hazard warning lamps

(

Y

page 109).

i

When towing with the hazard warning

lamps switched on, use the combination

switch as usual to signal a change of

direction. In this case, only the turn signals

for the desired direction flash. When the

combination switch is reset, the hazard

warning lamps start flashing again.

X

Turn the SmartKey to position 2 in the

ignition lock.

X

When the vehicle is stationary, depress the

brake pedal and keep it depressed.

X

Vehicles with manual transmission:

depress the clutch pedal.

X

Shift to neutral.

302

Towing and tow-starting

Breakd

own

assista

nce