beautypg.com

Safety, Occupant safety – Mercedes-Benz M-Class 2013 Owners Manual User Manual

Page 61

background image

Emergency Tensioning Devices, seat

belt force limiter

G

WARNING

Pyrotechnic Emergency Tensioning Devices

that have been deployed must be renewed.
For your safety, when disposing of Emergency

Tensioning Devices, always observe the

safety instructions. These are available from

any authorized Mercedes-Benz Center.
The PRE-SAFE

®

system has electrically

operated reversible pre-tensioners that do

not require replacement after activation.

!

If the front-passenger seat is not

occupied, do not engage the seat belt

tongue in the buckle on the front-

passenger seat. Otherwise, the Emergency

Tensioning Device could be triggered in the

event of an accident.

X

In order to ensure that the pyrotechnic

Emergency Tensioning Devices have not

been triggered, always have the seat belts

checked after an accident.

If the Emergency Tensioning Devices have

been triggered, they must be replaced.

The front seat belts and the outer seat belts

in the rear are equipped with Emergency

Tensioning Devices and belt force limiters.
The ETDs on the driver's and front-passenger

seat consist of pyrotechnic belt buckle

tensioners and belt anchor tensioners that

are triggered together. The belt buckle

tensioner is mounted on the B-pillar and the

belt anchor installing is mounted on the side

of the seat. After deploying, both tensioners

must always be replaced.
The ETDs tighten the seat belts in an accident,

pulling them close against the body.
The ETDs do not correct incorrect seat

positions or incorrectly fastened seat belts.
The ETDs do not pull vehicle occupants back

towards the backrest.
When triggered, seat belt force limiters help

to reduce the peak force exerted by the seat

belt on the vehicle occupant.

The belt force limiters for the front seats are

synchronized with the front air bags, which

take on a part of the deceleration force. This

results in the force exerted on the occupant

being distributed over a greater area.
The ETDs can only be activated when:

R

the ignition is switched on.

R

the restraint systems are operational; see

"SRS warning lamp" (

Y

page 43).

R

the belt tongue is engaged in the buckle on

each of the lap-shoulder belts in the front.

R

the front-passenger seat is occupied and

the belt tongue is engaged in the buckle on

the front-passenger side

The ETDs on the outside seats in the rear

compartment are triggered independently of

the lock status of the seat belts.
The ETDs are triggered depending on the type

and severity of an accident:

R

if, in the event of a head-on or rear-end

collision, the vehicle decelerates or

accelerates rapidly in a longitudinal

direction during the initial stages of the

impact

R

if, in the event of a side impact, on the side

opposite the impact the vehicle

decelerates or accelerates rapidly in a

lateral direction

R

if, in certain situations where the vehicle

overturns, the system determines that it

can provide additional protection

If the ETDs are deployed, you will hear a bang,

and a small amount of powder may also be

released. Only in rare cases will the bang

affect your hearing. The powder that is

released generally does not constitute a

health hazard. The 6 SRS warning lamp

lights up.

Occupant safety

59

Safety

Z