Mercedes-Benz CLA-Class 2014 Owners Manual - Manual (Page 120)

X Press retaining clips : at the same time in
the direction of the arrows.
X
Carefully remove the bulb holder with the
contacted connectors and the bulbs.
Bulb holder
:
Brake lamp
; Brake lamp
= Rear fog lamp
? Backup Light
A Turn signal
X
Brake lamp/rear fog lamp/backup
lamp: remove the corresponding bulb from
the bulb holder.
X
Insert the new bulb into the bulb holder.
X Turn signal lamp: lightly press the bulb
into the bulb holder, turn it counter-clock-
wise and remove it from bulb holder.
X
Insert the new bulb into the bulb holder and
turn it clockwise.
X Reinsert the bulb holder and engage on
retaining clips :.
X
Close the side trim panel (
Y
page 117).
Windshield wipers
Switching the windshield wipers
on/off
! Do not operate the windshield wipers
when the windshield is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windshield can
scratch the glass if wiping takes place when
the windshield is dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always
use washer fluid when operating the wind-
shield wipers.
! If the windshield wipers leave smears on
the windshield after the vehicle has been
washed in an automatic car wash, wax or
other residues may be the reason for this.
Clean the windshield using washer fluid
after washing the vehicle in an automatic
car wash.
Combination switch
1
$ Windshield wiper off
2 Ä Intermittent wipe, low (rain sensor
set to low sensitivity)
3 Å Intermittent wipe, high (rain sensor
set to high sensitivity)
4 ° Continuous wipe, slow
5 ¯ Continuous wipe, fast
B í Single wipe/î To wipe the wind-
shield using washer fluid
X
Switch on the ignition.
X
Turn the combination switch to the corre-
sponding position.
118
Windshield wipers
Lights
and
windshield
wipers