Mercedes-Benz C-Coupe 2015 Owners Manual - Manual (Page 348)

Model Engine
model
MB
Approval
C 250
C 250 Sport 271 229.5
C 350
C 350 4MATIC 276 229.5
C 63 AMG 156 229.5
Use only SAE 0W-40 or SAE 5W-40 engine oils
for AMG vehicles.
i MB approval is indicated on the oil con-
tainers.
Filling capacities
The following values refer to an oil change
including the oil filter.
Model Capacity
C 250
C 250 Sport 5.8 US qt (5.5 l)
C 350
C 350 4MATIC 6.9 US qt (6.5 l)
C 63 AMG With external oil
cooler: 9.0 US qt
(8.5 l)
Additives
!
Do not use any additives in the engine oil.
This could damage the engine.
Engine oil viscosity
Viscosity describes the flow characteristics
of a fluid. If an engine oil has a high viscosity,
this means that it is thick; a low viscosity
means that it is thin.
Select an engine oil with an SAE classification
(viscosity) suitable for the prevailing outside
temperatures. The table shows you which
SAE classifications are to be used. The low-
temperature characteristics of engine oils
can deteriorate significantly, e.g. as a result
of aging, soot and fuel deposits. It is therefore
strongly recommended that you carry out reg-
ular oil changes using an approved engine oil
with the appropriate SAE classification.
Brake fluid
G WARNING
The brake fluid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point of the brake
fluid is too low, vapor pockets may form in the
brake system when the brakes are applied
hard. This would impair braking efficiency.
There is a risk of an accident.
You should have the brake fluid renewed at
the specified intervals.
When handling brake fluid, observe the
important safety notes on service products
(
Y
page 343).
The brake fluid change intervals can be found
in the Maintenance Booklet.
346
Service products and filling capacities
Tec
hni
cal
data