Kontron AM4022 IPMI Firmware - Manual (Page 44)

IPMI Firmware AM4022
Page 44 ID 1052-3624, Rev. 1.0
For every channel, the AM4022 has these predefinitions in non-volatile memory:
Please note that the
ADMINISTRATOR
password is preset with
admin
.
Changed accounts and passwords stay valid after payload power-off.
The accounts must be activated using the following command:
11.6 IPMI Over LAN (IOL)
IPMI over LAN is used to allow the IPMI controller to communicate with the MMC via LAN using
the RMCP or the RMCP+ protocol. The data transferred are IPMI commands and the respons-
es to them.
To enable LAN support after parameter setup this command must be issued:
Please note that the following commands must use the IP address which belongs to the en-
abled channel.
The open tool “ipmitool” can serve as a control program and user interface for this. “ipmitool”
allows the issuing of generic IPMI commands such as:
or to call complex functions like “mc.info2:
This uses many generic IPMI commands to get the information needed.
11.7 Serial Over LAN (SOL)
Serial over LAN connects the COM1 or /dev/ttyS0 respectively of the AM4022's payload side
to an Ethernet channel. The MMC resides between this serial interface and one of the Ethernet
channels. It serves as an encoder and a decoder for the used RMCP+ protocol and controls
the data stream. Outside the AM4022 for example, the open tool “ipmitool” can be used to drive
the SOL session, i.e. it offers a console function to communicate via Ethernet with the
AM4022's serial interface.
The MMC firmware supports only “straight password authentication” SOL sessions with default
privilege level USER.
ID Name Callin Link Auth IPMI Msg Channel Priv Limit
1 false true true USER
2 admin false true true ADMINISTRATOR
ipmitool user enable
ipmitool lan set access on
ipmitool -I lan -H 192.168.3.189 -U admin -P admin -A PASSWORD raw 6 1
ipmitool -I lan -H 192.168.3.189 -U admin -P admin -A PASSWORD mc info