Kontron AM4022 IPMI Firmware - Manual (Page 38)

IPMI Firmware AM4022
Page 38 ID 1052-3624, Rev. 1.0
5.5.2 Firmware Upgrade - “ipmitool hpm”
Firmware upgrade using a HPM.1 file requires at least “ipmitool” version 1.8.10.
The firmware upgrade procedure starts with downloading the HPM.1 file using, for example,
the following command:
The next step is the activation of the newly downloaded MMC firmware. This is done using:
Detailed information about the currently active firmware versions or the redundant copies can
be obtained using the commands mentioned below.
To obtain detailed version information of the active MMC firmware, use the following command:
To obtain the version of the rollback copy (only valid if a newly downloaded firmware is already
activated), use the following command:
To obtain the version of the newly downloaded MMC firmware (only valid after download and
before activation), use the following command:
To obtain detailed information about the MMC’s HPM.1 upgrade capabilities, use the following
command:
To perform a manual rollback to the previously good firmware image, use the following com-
mand:
5.5.3 Firmware Upgrade - “ipmitool fwum”
“ipmitool” version 1.8.9 doesn’t support HPM.1 correctly. Tool versions prior to this do not
support HPM.1 at all.
The firmware upgrade procedure starts with downloading the binary firmware file using, for
example, the following command:
ipmitool hpm upgrade .hpm all
ipmitool hpm activate
ipmitool hpm compprop 1 1
ipmitool hpm compprop 1 3
ipmitool hpm compprop 1 4
ipmitool hpm targetcap
ipmitool hpm rollback
ipmitool fwum download .bin