Kontron AM4022 IPMI Firmware - Manual (Page 36)

IPMI Firmware AM4022
Page 36 ID 1052-3624, Rev. 1.0
5.4 Firmware / Module Identification
IPMI provides two methods to identify the AM4022 MMC firmware:
• Issuing the IPMI Command
Get Device ID
• Reading the Device Locator Record (SDR Type 12h)
A full description of the IPMI command
Get Device ID
and the Device Locator Record
(SDR Type 12h) can be found in the IPMI specification. For further information refer to Table
2, Related Publications.
IPMI Command:
Get Device ID
The response on the IPMI command
Get Device ID
offers the following information
(among others):
• Manufacturer ID = 3A98h / 15000d (Kontron IANA ID)
• Device ID = 20h (NXP® ARM7 microcontroller)
• Product ID = identifies the firmware (its board family firmware)
• Firmware revision (byte 4:5) reflects the version of the running firmware, which will
change after firmware update.
• SDR revision (byte 13, OEM extension) will be incremented with each firmware update
For a description of the OEM extensions refer to Chapter 3.1, “Get Device ID Command with
OEM Extensions”.
Device Locator Record
The Device Locator Record (SDR Type 12h) contains a Device ID String which identifies the
MMC as AM4022 MMC. Additionally, some run-time information such as AMC slot and slot-
dependent IPMB address is available in this record.
For example, when using the Linux “ipmitool” on a AM4022 placed in the first AMC slot of a
µTCA system, by calling:
the following information is displayed:
ipmitool sdr list mcloc
A1:AM4022 | … @72h | ok