Kontron AM4140 U-Boot Bootloader - Manual (Page 36)

U-Boot Usage AM4140 U-Boot Bootloader
Page 36 ID 1052-0281, Rev. 1.0
P R E L I M I N A R Y
6.2.2 Example of sconf Command Usage
6.2.2.1 sconf info
To get an overview of the possible interface configurations, invoke the “sconf info” command.
=> sconf info
List of available base configurations:
**< >** Stored base configuration
--[ ]-- ‘New’base configuration (work in progress)
========+-=============================================
Base |Port 0 Port 1 Port 4 Port 8
Config | ..7 ..11
========+-=============================================
|
**[ 0]**| GbE GbE SRIO @3.125 SRIO @3.125
|
< 1> | GbE GbE SRIO @3.125 GbE 4x1
|
< 2> | GbE GbE SRIO @3.125 PCIE [Gen.2]
|
< 3> | GbE [GbE] SRIO @2.5 SRIO @2.5
|
< 4> | GbE [GbE] SRIO @2.5 XAUI
|
< 5> | GbE [GbE] SRIO @2.5 PCIE [Gen.2]
|
< 6> | GbE [GbE] PCIE [Gen.2] PCIE [Gen.2]
|
< 7> | GbE [GbE] PCIE [Gen.2] XAUI
|
Note: [GbE] indicates that used DTSEC1 can be redirected to front panel
connector J2(GbE B). This may be required for board configurations which
otherwise do not provide front ethernet connectivity.
Board’s Port Configuration:
Option / Setting | Value # command, option
----------------------------------------------------------------
SRIO Sys.Size : small # sconf set srio
SRIO mode : agent # sconf set srio
AMC Port Activation / Forced settings (ignoring E-Keying):
Option / Setting | Value # command, option
---------------------------------------------------------------
Port 4 : auto # sconf set port4
Port 8 : auto # sconf set port8
=>