Kontron CP6004-RC - Manual (Page 40)

Introduction CP6004-RA/-RC
Page 1 - 20 ID 1055-1509, Rev. 1.0
D R A F T — F O R I N T E R N A L U S E O N L Y
1.8 Standards
The CP6004-RA/-RC complies with the requirements of the following standards:
Table 1-3: Standards for the CP6004-RA
TYPE ASPECT STANDARD REMARKS
CE Emission EN55022
EN61000-6-3 --
Immission EN55024
EN61000-6-2 --
Electrical Safety EN60950-1 --
Mechanical Mechanical Dimensions IEEE1101.10 --
Environmental Climatic Humidity IEC60068-2-78 93% RH at 40°C, non-condensing
See note below.
WEEE Directive
2002/96/EC Waste electrical and electronic equipment
RoHS 2 Directive
2011/65/EU Restriction of the use of certain hazardous sub-
stances in electrical and electronic equipment
Random Vibration
(Broadband) ANSI / VITA 47
(Class V2) Test parameters:
• 5-100 (Hz) frequency range: +3dB slope
• 100-1000 (Hz) freq. range: 0.04 (g²/Hz)
• 1000-2000 (Hz) freq. range: -6dB slope
• 7.619 g (rms)
• 60 (min) test duration/axis
• 3 axes
Single Shock ANSI / VITA 47
(Class OS1) Test parameters:
• 20 (g) acceleration
• 11 (ms) shock duration half sine
• 3 shocks per direction
• 6 directions
• 5 (s) recovery time
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.