Kontron CP6004-RC - Manual (Page 24)

Introduction CP6004-RA/-RC
Page 1 - 4 ID 1055-1509, Rev. 1.0
D R A F T — F O R I N T E R N A L U S E O N L Y
1.2 CP6004-RA Board-Specific Information
The CP6004-RA is a rugged air-cooled CompactPCI single-board computer with front I/O. It is
based on the 3
rd generation Intel® Core™ i7 processor and specifically designed for use in
highly integrated platforms with solid mechanical interfacing for a wide range of industrial
environment applications.
• Support for the following 3 rd generation processors:
• Intel® Core™ i7-3612QE (SV) quad-core processor, 2.1 GHz, 6 MB L3 cache
• Intel® Core™ i7-3555LE (LV) dual-core processor, 2.5 GHz, 4 MB L3 cache
• Intel® QM77 Express Chipset
• Up to 16 GB, dual-channel, soldered DDR3 SDRAM memory with ECC running at 1600 MHz
• Integrated 3D high-performance graphics controller with up to four high-resolution graphics
interfaces (VGA / DP / 2 x HDMI/DVI)
• 64-bit/66 MHz PCI or PCI-X CompactPCI interface (PICMG 2.0)
• One PMC slot with PCI functionality and rear I/O support; 64-bit/66 MHz PCI interface or
64-bit/133 MHz PCI-X interface
• One XMC slot utilizing a x8 lane PCI Express 2.0 interconnection
• Five Gigabit Ethernet interfaces:
•
Two Gigabit Ethernet interfaces switchable between front I/O and rear I/O
• Two Gigabit Ethernet interfaces on rear I/O (PICMG 2.16)
• One Gigabit Ethernet interface on front I/O
• Two Gigabit Ethernet (GbE) controllers:
•
One Intel® 82579LM Gigabit Ethernet controller connected to one GbE port on the front panel
• One Intel® 82580EB Quad Gigabit Ethernet controller connected to two GbE ports on
the front panel and two GbE ports on the rear I/O
• Five Serial ATA interfaces with SATA RAID 0/1/5/10 support:
•
One onboard SATA 6 Gb/s interface for the Serial ATA Flash module
• Four SATA 3 Gb/s interfaces on the rear I/O
• Six USB ports:
•
Two USB 2.0 ports on the front panel
• Four USB 2.0 ports on the rear I/O
• Two COM ports:
•
One RS-232 COM port either on the front panel or on the rear I/O (COMA)
• One RS-422/RS-232 COM port on the rear I/O (COMB)
• TCG 1.2 compliant Trusted Platform Module (TPM), on request
• Two SPI boot flashes:
•
One standard SPI boot flash
• One recovery SPI boot flash
• Four general purpose inputs (GPI) and four general purpose outputs (GPO) on rear I/O
• Watchdog timer
• Battery-backed real-time clock
• Three onboard DIP switches for board configuration
• Supports PICMG Packet Switching Backplane Specification 2.16
• IPMI support
• 4HP, 6U CompactPCI
• Passive heat sink solution for forced airflow cooling
• Rear I/O on J3, J4 and J5
• Hot swap capability: as system controller or as peripheral device
• AMI Aptio®, a uEFI-compliant platform firmware