Kontron CP6004X-SA - Manual (Page 30)

Introduction CP6004X-SA
Page 1 - 12 ID 1054-1227, Rev. 1.0
D R A F T — F O R I N T E R N A L U S E O N L Y
Interfaces
Standard Rear I/O The following interfaces are routed to the rear I/O connectors J3 and J5.
• COMA (RS-232 signaling) and COMB (RS-232 signaling); no buffer on
the rear I/O module is necessary
• 4 x USB 2.0
• 1 x CRT VGA, 2 x HDMI/DVI
• 1 x HDA
• 2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)
• 4 x SATA 3 Gb/s
• 4 x GPIs and 4 GPOs (LVTTL signaling)
• System write protection
High-Speed Serial Rear
I/O Interconnection The following interfaces are provided on the rear I/O via two ZDplus high-
speed connectors, J4 and J41 (PICMG 2.20):
• Two 10GBASE-KR interfaces
• One x4 PCI Express 2.0 operating at 5 GT/s as a root complex controller
only
The port mapping of the high-speed serial rear I/O interconnection on the
CP6004X-SA is capable of supporting two 10GBASE-KR/40GBASE-KR4 inter-
faces, one x8 PCI Express 3.0 operating at 8 GT/s, and two SATA 6 Gb/s
ports. However, the current implementation provides support for only two
10GBASE-KR and one x4 PCI Express 2.0 operating at 5 GT/s.
10 Gigabit Ethernet
Two 10GBASE-KR interfaces for high-speed serial rear I/O interconnection
based on the Intel® 82599 dual-port 10 Gigabit Ethernet controller
Gigabit Ethernet
Five 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on one Intel® 82579LM Gigabit Ethernet controller and one Intel®
I350 quad-port Gigabit Ethernet controller:
• Three RJ-45 connectors on the front panel
• Two ports on the rear I/O (PICMG 2.16)
• Automatic mode recognition (Auto-Negotiation)
• Automatic cabling configuration recognition (Auto-MDI/X)
USB
Six USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
• Two type A USB 2.0 connectors on the front panel
• Four USB 2.0 ports on the rear I/O interface
Serial Two 16C550-compatible UARTs:
• One RS-232 port on the front panel and routed to rear I/O, COMA
• One RS-232 port on the rear I/O, COMB
XMC XMC interface:
• One onboard XMC connector for connecting a standard XMC module
• Up to x8 lanes PCI Express 2.0 ports operating at 5 GT/s
SATA Two SATA 6 Gb/s interfaces for:
• Up to 64 GB flash memory via an onboard SATA Flash module, or
• Onboard 2.5" HDD / SSD is supported in combination with the
MMADP-SATA01 module
• One standard SATA 6 Gb/s interface for the standard SATA connector
Four SATA 3 Gb/s ports accessible via rear I/O
Table 1-1: CP6004X-SA Main Specifications (Continued)
FEATURES SPECIFICATIONS