Kontron CP6003-RC uEFI BIOS - Manual (Page 53)

CP6003-SA/RA/RC uEFI BIOS The uEFI Shell
ID 1045-9149, Rev. 2.0 Page 53
P R E L I M I N A R Y
USAGE: Set IPMI controller mode:
COMMAND / RESPONSE:
Shell> kipmi mode
Set Serial-over-LAN I/O/SOL parameters:
COMMAND / RESPONSE:
Shell> kipmi net 1
Display system event log:
COMMAND / RESPONSE:
Shell> kipmi sel list
Show sensor related information:
COMMAND / RESPONSE:
Shell> kipmi sensor list
Execute raw command. Example: Get self-test results.
COMMAND / RESPONSE:
Shell> kipmi raw 0x06 0x00 0x04
Execute raw SendMessage command:
COMMAND / RESPONSE:
Shell> kipmi rawsendmessage 0x20 0x00 0x06 0x00 0x01
SETTINGS: fru []: Displays FRU data
Options:
Fru device ID:
Numeric FRU device ID. The FRU ID 0 is used by
default if no FRU ID is entered.
ipmb: Displays IPMB bus settings
ipmb redundant: Switch IPMB bus to redundant mode
ipmb single: Switch IPMB bus to single mode
Note: The redundant mode is not available on the CP6003-SA/RA/RC.
Please leave this function at single mode.
irq : Display/Set the IRQ number of the KCS interface
Options:
0:
KCS uses no IRQ
10: KCS uses IRQ 10
11: KCS uses IRQ 11
The board must be reset for the settings to apply.
kipmi (continued)