Kontron CP-RIO6-923 - Manual (Page 11)

Preface
xi CP-RIO6-923 User Guide
www.kontron.com
Special Handling and Unpacking
Instructions
Unpacking
Follow these recommendations while unpacking:
• Remove all items from the box. If any items listed on the purchase order are missing, notify Kontron
customer service immediately.
• Inspect the product for damage. If there is damage, notify Kontron customer service immediately.
• Keep all the original packaging material for future storage or warranty shipments. If it is necessary to
store or ship the board please re-pack it as nearly as possible in the manner in which it was delivered.
Do not handle this product out of its protective enclosure while it is not used for operational purposes unless
it is otherwise protected.
Whenever possible, unpack or pack this product only at EOS/ESD safe work stations. Where a safe work sta-
tion is not guaranteed, it is important for the user to be electrically discharged before touching the product
with his/her hands or tools. This is most easily done by touching a metal part of your system housing.
It is particularly important to observe standard anti-static precautions when changing mezzanines, ROM
devices, jumper settings etc. If the product contains batteries for RTC or memory back-up, ensure that the
board is not placed on conductive surfaces, including anti-static plastics or sponges. They can cause short
circuits and damage the batteries or conductive circuits on the board.
Powering up the System
Before any installation or setup, ensure that the board is unplugged from power sources or subsystems.
If you encounter a problem, verify the following items:
• Make sure that all connectors are properly connected.
• Verify your boot devices.
• If the system does not start properly, try booting without any other I/O peripherals attached, including
AMC adapters.
ESD Sensitive Device
This symbol and title inform that electronic boards and their components are sen-
sitive to static electricity. Therefore, care must be taken during all handling oper-
ations and inspections of this product, in order to ensure product integrity at all
times.