Kidco G24 User Manual
Page 3
Basic gate
!
Place extension between the two basic gate
sections.
Adjust gate sections, until gate is approxi-
mately right width and adjustment holes are
aligned on top and bottom. Sections should fit
without any distance between bars.
When adding more than one extension (G60
only) add in continuation of first extension.
IMPORTANT
Gate must NOT be extended any further
than 4 holes from spindle ends.
Place one set of expansion screws and screw
sockets in top and bottom set of overlapping
adjustment holes nearest hinge side of gate
and second set of expansion screws and
screw sockets in overlapping holes nearest
locking side of gate. Tighten with a screw-
driver.
3