beautypg.com

Engine oil, Checking oil level – Jeep 2015 Compass - Owner Manual User Manual

Page 485

background image

CAUTION!

Failure to properly maintain your vehicle or per-

form repairs and service when necessary could
result in more costly repairs, damage to other
components or negatively impact vehicle perfor-
mance. Immediately have potential malfunctions
examined by an authorized dealer or qualified
repair center.

Your vehicle has been built with improved fluids

that protect the performance and durability of your
vehicle and also allow extended maintenance inter-
vals. Do not use chemical flushes in these compo-
nents as the chemicals can damage your engine,
transmission, power steering or air conditioning.
Such damage is not covered by the New Vehicle
Limited Warranty. If a flush is needed because of
component malfunction, use only the specified
fluid for the flushing procedure.

Engine Oil

Checking Oil Level
To assure proper engine lubrication, the engine oil must

be maintained at the correct level. Check the oil level at

regular intervals, such as every fuel stop. The best time to

check the engine oil level is about five minutes after a

fully warmed engine is shut off. Do not check oil level

before starting the engine after it has sat overnight.

Checking engine oil level when the engine is cold will

give you an incorrect reading.
Checking the oil while the vehicle is on level ground and

only when the engine is hot, will improve the accuracy of

the oil level readings. Maintain the oil level between the

range markings on the dipstick. The range markings will

consist of a crosshatch zone which depicts the MIN at the

low end of the range and MAX at the high end of the

range. Adding 1 qt (1L) of oil when the reading is at the

7

MAINTAINING YOUR VEHICLE 483