Service the parksense® park assist system – Jeep 2014 Grand Cherokee - Owner Manual User Manual
Page 231
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the
ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORS
Љ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORS
Љ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED
Љ message for five seconds.
When the shift lever is moved to Reverse and the system
has detected a faulted condition, the EVIC will display a
ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ,
ЉPARKSENSE UNAVAILABLE WIPE FRONT SENSORSЉ
or
ЉPARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with
ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
arc alerts will interrupt the
ЉPARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS
Љ, ЉPARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORS
Љ, or ЉPARKSENSE UN-
AVAILABLE SERVICE REQUIRED
Љ messages if an object
is detected within the five second pop-up duration. The
car graphic will remain displayed for as long as the
vehicle is in REVERSE. Refer to “Electronic Vehicle
Information Center (EVIC)” in “Understanding Your
Instrument Panel” for further information.
If
ЉPARKSENSE UNAVAILABLE WIPE REAR SENSORSЉ
or
ЉPARKSENSE UNAVAILABLE WIPE FRONT SEN-
SORS
Љ appears in the Electronic Vehicle Information
Center (EVIC) make sure the outer surface and the
underside of the rear fascia/bumper and/or front fascia/
bumper is clean and clear of snow, ice, mud, dirt or other
obstruction and then cycle the ignition. If the message
continues to appear see an authorized dealer.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
229