Jeep 2007 Wrangler - Manual (Page 130)

6. Locate the wiring harness at the rear left side corner of
the vehicle.
7. Disconnect the washer hose and install the tethered
cap.
CAUTION!
Make sure storage cap is installed to prevent foreign
materials from entering tube and clogging system,
and also prevent fluid from being sprayed into rear
of vehicle.
8. Disconnect the wire harness from the hard top by
pressing the tab at the side of the connector and pulling
to disconnect.
NOTE: If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected from the hard
top.
130 UNDERSTANDING THE FEATURES OF YOUR VEHICLE