Jeep 2004 Wrangler - Manual (Page 81)

7. Disconnect the washer hose and install the tethered
cap.
CAUTION!
Make sure storage cap is installed to prevent foreign
materials from entering tube and clogging system.
8. Disconnect the wire harness from the hard top by
pressing the tab at the side of the connector and pulling
to disconnect.
NOTE: If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected from the hard
top.
9. Remove the hard top from the vehicle.
10. Fold the harness back and secure it to the main
harness using the attached Velcro
௡ strap, to prevent the
harness from rattling.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 81
3