Jeep 2004 Wrangler - Manual (Page 123)

Power Switch, Volume Control
Press the ON/VOL control to turn the radio on. Turn the
volume control to the right to increase the volume.
Seek Button (Radio Mode)
Press and release the Seek button to search for the next
station in either the MW/LW or FM mode. Press the top
of the button to seek up and the bottom to seek down.
The radio will remain tuned to the new station until you
make another selection. Holding the button in will by-
pass stations without stopping until you release it.
Tuning
Press the TUNE control up or down to increase or
decrease the frequency. If you press and hold the button,
the radio will continue to tune until you release the
button. The frequency will be displayed and continu-
ously updated while the button is pressed.
Balance
The Balance control adjusts the left-to-right speaker bal-
ance. Push in the button and it will pop out. Adjust the
balance and push the button back in.
Fade
The Fade control provides for balance between the front
and rear speakers. Push in the button and it will pop out.
Adjust the balance and push the button back in.
Tone Control
Slide the Bass and/or Treble controls up or down to
adjust the sound for the desired tone.
AM/FM-TAPE/CD/CD-C
Press the top of this button to switch between MW, FM,
and LW. Press the bottom of this button to switch
between Tape, CD, and optional CD changer control
operation.
To Set The Radio Push-button Memory
You can store a total of 10 FM, 5 MW and 5 LW stations
into memory.
When you are receiving a FM station that you wish to
commit to push-button memory, press the SET button.
SET 1 will appear in the radio display window. Select the
push button you wish to lock on this station and press
and release that button. If a button is not selected within
UNDERSTANDING YOUR INSTRUMENT PANEL 123
4