Hollywood Racks Giant Revive - Manual (Page 3)

Fig. 5
Fig. 6
Above: Mounting bike to the “inside”
bike holder.
Fig. 7
Hold handlebars to prevent them from rotating
onto you when tying down the bike(s)
Fig. 8
Carrying two Revive bikes - Placing the
second bike on the outside bike holder:
When carrying two Revive bikes, the above
instructions apply except that the second bike
will have
to “share” the anti-sway bar with the
first bike. You can also use the main frame
for stabilizing the first bike. Use the other two
30” tie downs for the second bike, and be
sure to wrap the 86” long tie-down strap
around the main frame and both bikes. You
can also tie the two front wheels together to
prevent them from moving.
Finally, use the long 86” tie-down strap for extra holding security. Wrap this strap behind the
main frame then around the bike and wheels. Loop the strap end through buckle and tighten.
Be sure front wheel is not “flopping” around.
Important Note:
After the bikes are installed on the rack, go
back and retighten all six straps as they will
have loosened under tension. Always
check the rack, bikes and strap tightness
regularly during use.