Hollywood Racks HR135 Tow N Go - Manual (Page 2)

.
Installation Instructions:
1. Install your trailer hitch receiver tube through
the base of the rack (at the bottom of the main
beam. See Fig. 1
2. Locate the base as far forward as possible.
3. Using Allen wrench supplied, tighten the 4 set
screws on the base unit until snug.
Support Arms (Fig. 2.1)
Rotate the support arm and align the plate
holes with the tube holes per Fig. 2a. Insert pin
and close safety clasp over pin end. To return
the support arm to it’s folded position, undo the
safety clasp, then hold the arm with one hand
and remove the pin so the arm doesn’t drop
quickly). Re-insert the pin per Fig. 2b.
2009 version
Qty Description
1 Tow ‘n Go bike rack with Tie Down
strap attached to rack
9 Rubber Bike Cradle straps
1 Allen wrench for set screws
Fig. 1
Fig. 2a
Fig. 2b
”in-use” position
“folded” position
Caution when using this rack and NOT towing!
This bike rack can also be used when not
towing, however your trailer hitch receiver tube
(or “stinger”) is most likely not to include an
anti-wobble device. An anti-wobble device
such as a threaded hitch pin is intended to
keep the rack stable during use. Hollywood
Racks strongly recommends that you either
purchase an “after market” anti wobble device
for your hitch or use some tie-down straps to
secure the rack to the vehicle to prevent any
rack movement. If you have any questions on
how to do this, please call us at 800-747-4085.