Hollywood Racks HR1000 SportRider 2 bike - Manual (Page 6)

18d
Tips for carrying
woman’s bikes and
bikes with slanted
top tubes
Adjust the wheel
trays so that the
hook will rest in the
bike frame’s top tube
and seat tube, as
shown in Fig. 19a
and 19b
.
19a
19b
Double check before driving off :
- Knobs are tight on all four wheel trays and
- Frame hooks are pushed all the way down
- All three retaining pins are properly inserted and secure
- Wheel straps are fastened
- Hitch pin is secure and hitch pin clip is installed
- Drive slowly on bumpy or dirt roads
6
Optional accessories
for your Sport Rider
Locking threaded
hitch pin
part no. LHPT
Locking Threaded
hitch pin with
security cable
part no. LHPTC
Final Step: Install wheel tube stop screws: After you have installed the
bikes on the rack and are comfortable with the positions of the wheel holders,
the stop screws can be installed. Locate items P from hardware bag. Thread
them into the hole located on the bottom of wheel tubes (Fig. 20), and tighten
with a flat edge screwdriver. The screws are removable.
Fig. 20a
Fig. 20b
To release the frame
hook, depress the
Lever and pull the
hook up.
Tip: you may have
to push the hook
down a bit while
holding in the lever
to release it.
18e