Hollywood Racks HR1000 SportRider 2 bike - Manual (Page 5)

Folding Up the Wheel Holders
To fold up the wheel holders, rotate and remove
the front retaining pins. Then rotate the tube up
and re-install the pins. See Fig. 17a &17b
Pre- position the wheel trays to fit the bike’s wheel base (center to center distance between the wheel axels) such
that they are directly beneath each wheel. To adjust the wheel trays, loosen the knobs and slide along the wheel
holder support tube. Tighten knobs securely.
To fit the first bike (closest to the vehicle) more easily, the vertical post may be tilted down (away from vehicle).
To do this, simply remove the side retaining pin per. Note: Never fold down main tube with bike(s) mounted. Place
the first bike in the wheel holders, and then rotate the vertical post up per Fig 16d. Handlebars for the first bike
should be on the driver’s side of the vehicle. If carrying two bikes, always load the smaller bike first (position the
smaller bike between the vehicle and vertical post)
Be sure that the hooks are well supported on the bike’s frame. Push hook firmly down onto bike frame as shown
in Fig 18d. Try pulling up on the hook to be sure the clamp is properly engaged. Use the Velcro strap on the
wheel holder as the final step of installing the bikes on the rack, per Fig. 18e.
Repeat for the outside/second bike with the short hook.
Installing Bikes on the Rack
17a
17b
5