Hollywood Racks HR420A Road Runner Aluminum 4 bike - Manual (Page 4)

4
5. Anti-Theft Security
For anti-theft security, the rack comes with a keyed alike locking hitch pin and a security cable G with
an integrated lock. Wrap the cable around the bike frames, their wheels and through the rack. Secure
by inserting end of cable in the lock.
6. Removing Rack and Bikes:
To remove the bikes, simply undo the straps and gently lift the bikes off. If you’re in a parking lot,
be sure to fold down the support arms to minimize the length of the rack when not in use. To remove
the rack from the vehicle, fold the support arms and lower brace, and remove the Locking Hitch Pin.
Unscrew (counter-clockwise) the “no wobble” lever and slide the rack out of the hitch receiver.
7. Backing out of driveways and going over bumps
Please keep in mind that when transporting bikes, you will be carrying more weight on your hitch.
This means the rear of your vehicle will be lower to the ground. When going up driveways or over
bumps, drive slowly and at an angle if possible. If you have
a car or minivan where the hitch is low to the ground, the rack
may hit the ground. Go slowly and please be sure the handle
lever for the no wobble system is turned up or to the side.
8. Tilting the rack down:
Refer to Fig. 5 (page 2): Remove lynch pin clip and
lynch pin to tilt the rack down for easy access to the
rear of your vehicle.
Hollywood Racks 12812 S. Spring St. Los Angeles, CA 90061 www.hollywoodracks.com
(800) 747-4085 or (310) 516-8600 FAX (310) 516-8955 [email protected]
Customer Service: M-F 8:00 AM – 3:00 PM PST Made in Taiwan 123009 rev e
Limited Lifetime Warranty (effective January 1, 2008):
Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the
product subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials and
workmanship by repairing or replacing (at its option) a defective part or the complete rack without charge for labor or
parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
This warranty does not cover problems caused by normal wear and tear including (but not limited to) weather,
scratches, dents, rust, accidents, unlawful vehicle operation, misuse, abuse, neglect, theft, unauthorized modifications,
or unauthorized repair. No warranty is given for defects resulting in incorrect assembly, incorrect installation onto the
vehicle, installation on a “no fit” vehicle, incorrect attachment of bicycles onto the rack, or overloading of the rack’s
weight restrictions. This warranty terminates if the original retail purchaser transfers the product to any other person.
If a product is believed to be defective, the original retail purchaser should contact either the original retailer or
Hollywood Racks directly at 800-747-4085 or at [email protected]
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as
determined by Hollywood Ra
cks) is a purchaser’s exclusive remedy under this warranty. Damage to a purchaser’s
vehicle, cargo, bicycles and or to any other person is excluded. This warranty is expressly made in lieu of any and all
other express warranties, whether oral or written.
Hollywood Racks shall not be liable for any direct, indirect, consequential, incidental, special, punitive or any other
damages in connection with the purchase, use or handling of this product.
Some states do not allow the exclusion or limitation of consequential or incidental damages and the above limitation may
not apply to you. This warranty gives you specific legal rights and you have other rights, which vary from state to state.
Fig. 10