Gastroback 46008 Design Vakuum Sealer Plus - Manual (Page 7)

29
• After each sealing process let the appliance cool down for approximately 30 seconds
(with lid left open) before starting again. only use the designated foils, bags and
containers with the appliance to avoid damage. Ensure that the appliance will not
suck in any liquid or powder.
• Do not vacuum pack inflammable liquids (e.g. alcoholic beverages, sol-
vents). caused by low pressure, large amounts of liquid will evaporate,
thus building-up a hazardous explosive mixture. Additionally, the appliance will
get damaged.
• Containers used for vacuuming may not have any cracks and scratches. Thus, carefully
check all containers used with the appliance for perfect condition. Do not use any other than
the designated containers. Damaged or unsuited containers can burst under vacuum with
splinters hurled about! Always handle containers under vacuum with special care, to avoid
bursting. Do not consume any food from a crushed container, because splinters could be in
the food, thus causing severe injuries.
• Do not leave the appliance unattended while connected to the power supply. Always
unplug the appliance, and wait until the sealing band cooled down, before moving, or
cleaning, or when the appliance is not in use. Do not grasp the appliance at the open lid
or power cord for moving the appliance.
• Always unplug and wait for the appliance to cool down, before cleaning or storing.
Close the lid to protect sealing band and gaskets for moving or storing.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any
corrosive chemicals (e.g. bleach) for cleaning. Do not immerse the appliance or power
cord in water or any other liquid. Do not spill or drip any liquids on the appliance, or on
the power cord to avoid risk of fire and electric shock. When liquids are spilled in the motor
housing or sucked in, immediately switch OFF the appliance (CANCEL button), unplug the
appliance, and wait for the appliance to cool down. Thereafter, clean and dry the appli-
ance thoroughly. (See: ›Care and Cleaning‹)
• Do not place the appliance or any parts in an automatic dishwasher.
important safeguards for electrical appliances
The appliance is driven electrically. Place the appliance near a suitable wall power socket
to connect the appliance directly to a protected mains power supply with protective conduc-
tor (earth/ground) connected properly. Ensure that the voltage rating of your mains power
supply corresponds to the voltage requirements of the appliance (220-240 V, 50 Hz, AC,
rated for at least 8 A). The installation of a residual current operated circuit breaker (r.c.c.b.)
with a maximum rated residual operating current of 30 mA in the supplying electrical circuit
is strongly recommended. If in doubt, contact your electrician for further information.
• Do not use multiple electrical adapters. We recommend avoiding the usage of extension
cords. However, if you wish to use an extension cord, ensure that the protective conductor
is connected properly.
• Do not leave the appliance unattended while connected to the power supply. Always
immediately unplug the appliance after use and before cleaning. Always grasp the plug
when disconnecting the appliance from the power outlet.