Gastroback 46008 Design Vakuum Sealer Plus User Manual

Page 14

Place the open end of the bag in the middle of the sealing

gasket. If you wish to generate a vacuum, the bag must reach

into the vacuum chamber (picture G).
tiP: Ensure that no food particles, liquids, or grease are in the

sealing section of the bag. Otherwise the seam could be leaking.
3.

Close the lid and press the lid down at the marked lines

(picture h). Ensure that the lid is securely locked and the lock

has engaged (you will hear a clicking sound when the lid snaps

shut). The appliance is now ready for use.
4.

Choose the type of food you are going to vacuum (pic-

ture i). You can choose between: »DRY«, »MOIST«, »SOFT«,

»DELICATE«. If you make no selection, the setting of »DRY« is

automatically selected - the indicator light illuminates green.
5.

Press the »VACUUM & SEAL« button (picture J). The vacuum

pump indicator illuminates red. The vacuum pump is audibly

working and the foil clings to the content of the bag. As soon

as the vacuum procedure is finished the sealing indicator

(»MANUAL SEAL«) illuminates blue and the appliance starts to

seal the bag. The complete process is finished as soon as both

indicators switch off.
6.

Press the lock release buttons on either side of the appliance

to open the lid and take out the bag (picture K).
imPortant: The sealing band could get hot after repeated

sealing processes. Do not touch the sealing band with any parts

of your body or heat-sensitive items immediately after sealing.
7.

Check if the seam is even and smooth. The bag is sealed pro-

perly, if there is a smooth line with no interruption and crease on

the seam. If in doubt, just place another seal near the first one.

For this, use the Seal Only button.
note: If the desired vacuum is not reached, the vacuum system

will shut down automatically after 30 seconds without entering

the sealing process. In this case, check whether the bag has a

leak, or the bag was not placed properly. The appliance is not

intended for continuous operation. Please wait for approximately 30 seconds with the lid

open, before starting a new sealing process.
8.

If there are any liquids (e.g. condensate) or parts of the food in the dripping tray, clean

the dripping tray, before starting the vacuum pump again. For this, you can take out the

dripping tray.
9.

Unplug the appliance, when you have finished operating.

Picture G

Picture J

Picture H

Picture I

Picture K