Gastroback 41406 Design Mincer Electronic Pro - Manual (Page 6)

• Do not use the appliance if it is damaged or units of the appliance are damaged.
Do not use the appliance if it does not function properly or if it was excessively
loaded. The appliance is likely damaged if the appliance or units of the appliance
show cracks, exorbitant wearing down, alterations or leaks. It is also likely damaged
if the drive wheel of the motorblock moves slowly. Take the appliance for technical
maintenance and repair to an authorised specialised reparation shop.
• Never use force assembling or disassembling the appliance. The single parts
should be put together easily. Only operate the mincer after it has been carefully
assembled following the instructions ´Assembling the appliance`.
• Never use the crossed-blade knife and grinding disc in combination with the sau-
sage filling attachment, adaptor disc, cookie attachment or Kebbe attachment. Only
use either the crossed-blade knife with the grinding disc or one of the attachments.
• Always turn the appliance off (pressing the on and off button and then the power
button), wait for the motor to stop moving before pulling the plug or disassembling
the mincer.
• For the case that the worm housing or the closing ring loosen while operating turn
off the appliance immediately (pressing the on and off button and then the power button)
and pull the plug. Operate according to the instructions ´Trouble shooting` before
turning the appliance on again.
• The mincer must only be used to process meat and vegetables. Do not mince
hard parts such as bones. Do not mince hard-fibre foods such as ginger, etc. The
mincer cannot mince hard or stingily ingredients (for example: bones, nuts, ginger).
If you use hard ingredients like onions or carrots, you have to steam them before add-
ing them to the meat otherwise they can block the motor. If the motor or if the worm
is blocked turn off the mincer (pressing the on and off button and then the power button)
and wait for approx. 6 seconds to be certain that the motor is no longer running.
Work according to the instructions ´Trouble shooting` before continuing operation.
• Do not let the motor run permanently for longer then 3 minutes to avoid over-
heating. After 3 minutes turn off the appliance and let the motor cool down for at
least 60 minutes before continuing operation.
Movable and sharp-edged units – risk of injury
• Never put fingers, wooden spoons or other foreign substance (such as hair, clothing,
brushes, cloths) into the feed chute or the holes of the grinding disc when the appliance
is plugged into the power point. Always ensure that there is no foreign substance
(such as bones, stems of vegetables or wooden spoons) in the feed chute before turning
on the appliance. Only use the provided pusher to push food through the feed chute.
While proceeding do not push the pusher too hard down to avoid blocking the motor.
28