Gastroback 41406 Design Mincer Electronic Pro - Manual (Page 11)

33
ATTENTION: Do not use any tools, for tightening the screw and pay attention not to
cant the screw. If the screw cants the screw thread gets damaged. If the screw does
not turn easily put some sunflower oil (or other edible oil) on the screw.
4. Refer to ´Assembling for mincing` step 3 for further steps for assembling.
Assembling for making cookies
1. Picture C: Take the worm housing into the right
hand and insert with your left hand the worm inside
the worm housing. The side of the worm with the plas-
tic end has to face the worm housing when putting
it inside the worm housing. If the worm is correctly
assembled when the plastic end of the worm pokes a
few millimetres out of the worm housing.
2. Take the adaptor disc. The small end with the
recess has to face the worm when attaching. If necessary turn the adaptor disc a
little bit until the arresting pin of the worm housing locks precisely into the correspon-
ding recesses of the adaptor disc.
IMPORTANT: If the tools overlap the edges of the worm housing the worm is not
placed all the way inside of the worm housing. Turn the worm a little bit to make it
fit inside but do not use force. If mounted correctly the adaptor disc is flush with the
front of the worm housing and the axis of the worm pokes out 2 mm of the grinding disc.
3. Place the cookie attachment on the worm housing. The flat
end has to face the worm housing when attaching. Fit the closure
ring over the cookie attachment (picture D). Firmly screw the
closing ring on the worm housing and tighten by hand.
ATTENTION: Do not use any tools, for tightening the screw and
pay attention not to cant the screw. If the screw cants the screw
thread gets damaged. If the screw does not turn easily put some
sunflower oil (or other edible oil) on the screw.
4. Refer to ´Assembling for mincing` step 3 for further steps for
assembling.
5. If the appliance is assembled take the cookie attachment
blade and slide it into the cookie attachment (picture E)
and choose the desired cookie shape. Ensure the handle is
facing away from the attachment when sliding it in other-
wise you cannot use the cookie shape that is the closest to
the handle (picture F).
The cookie attachment is ready for operation.
C
D
E
F