Gastroback 40969 Design Stand Mixer Advanced - Manual (Page 12)

attENtION: Keep hands and other utensils out of bowl while blending
food to reduce the risk of severe injury to persons or damage to the unit. A
scraper may be used but must be used only when the unit is not running.
Take the splash guard off the bowl.
Push the head release lever with your right hand upwards (picture J).
Grab hold of the motor head in front of the processing tool with your
left hand and rise the motor head. Rise the motor head until locked into
position.
NOtE: Release the head release lever as soon as you are possible to
rise the motor head. The head release lever will lock in the lower position
as soon as the motor head is risen.
Disassembling the processing tools
Push the attachment of the processing tool upward until it is released of
the indent (picture K). Turn the processing tool clockwise until the guid-
ing pin of the motor head fits through the cannelure of the processing
tool (picture L/M).
You can release the processing tool now by pulling it downward.
Clean the appliance after use in accordance to the instructions in chap-
ter Care and Cleaning. Do not leave any food dry on the surfaces of the
appliance.
CarE aND ClEaNING
warNING: To avoid injuries to persons and damage, always switch
´Off` the appliance, wait for the motor to stop completely and unplug the
appliance immediately after operation and before disassembling or clean-
ing the appliance. With the appliance connected to the power supply, do
not touch the assembled tools with your hands or any objects.
DO NOt place the appliance, accessories or power cord in an automatic
dishwasher. Do not immerse the motor housing or power cord in any liq-
uids or spill any liquids on it. Always wipe off spilled liquids immediately.
CautION: Do not use abrasive cleaners, cleaning pads, corrosive chemi-
cals (disinfectants, bleach) or any sharp or hard objects (i.e. metal scouring
pads) for cleaning, for this could damage the surfaces. Carefully clean the
appliance with a damped sponge or cloth and warm soapy water.
1.
Switch ›Off‹ (speed control into ›Off‹-position), wait for the motor to
stop completely and unplug the appliance from the power outlet.
2.
Disassemble the processing tool regarding the instructions ›Disassembling
the processing tools.
3.
Clean the processing tool with a soft nylon washing brush and warm
dish-water. Rinse the processing tool thoroughly under running water.
attENtION: Do not clean the processing tool in an automatic dish-
washer.
N
K
locked
l
M
released
locked
J
38