ETS-Lindgren HI-4455 Isotropic Field Probe (Archived) - Manual (Page 22)

HI-4455 Isotropic Electric Field Probe
© ETS-LINDGREN L.P. – August 2005
Revision D- Part No. H-600076
22
Step 2. The sensor and electronics housing are engineered to operate
as a unit and MUST be returned together. Carefully package the probe
assembly in the carrying case. Use the original boxes and packing
materials, if possible. If not, use the Parts List in Table 1 to order new
boxes and foam packing from ETS-Lindgren.
If the probe is under warranty, refer to the Limited Warranty section of
this manual for additional information about your return.
PERIODIC/PREVENTIVE MAINTENANCE
The HI-4455 probe assembly (sensor and electronics housing) require
an annual calibration check to verify that they are performing within
specifications. ETS-Lindgren Service Personnel may perform this
calibration check at the factory. Return your probe(s), using the original
packing materials (if possible), to:
ETS-Lindgren
Attn: Customer Service
1301 Arrow Point Drive
Cedar Park, Texas, USA 78613
Archived 4/2/10