Getting started, Archived 4/2/10 – ETS-Lindgren HI-4455 Isotropic Field Probe (Archived) User Manual

Page 11

HI-4455 Isotropic Electric Field Probe

2. GETTING STARTED

UNPACKING AND ACCEPTANCE

Step 1. Upon delivery of your order, inspect the shipping container(s) for
evidence of damage. Record any damage on the delivery receipt before
signing. In case of concealed damage or loss, retain the packing
materials for inspection by the carrier.

Step 2. Remove the probe from its shipping containers. Save the boxes
and any protective packing materials for future use.

Step 3. Check all materials against the packing list to verify that the
equipment received matches what was ordered. If you find any
discrepancies, note them and call ETS-Lindgren Customer Service
(+1.512.531.6400) for further instructions.

Be sure that you are satisfied with the contents of your order and the
condition of your equipment before installing the probe.

PROBE

A switch, two fiber optic connectors and a battery charger connector are
mounted on the HI-4455 electronics housing (Figure 2).

XMIT/RCV

The fiber optic cable assembly from the receiver is attached to the probe
via two connectors. The cables are color-coded: white for XMIT, yellow
for RCV. Identically colored dots are located on the electronics housing
adjacent to these connectors. Be sure that each cable is attached to the
proper probe connector.

Archived 4/2/10