ETS-Lindgren HI-3550 Magnetic Field Monitor (Archived) - Manual (Page 24)

HI n 3550 Manual Page — 19
Figure 10
Leading Zeros Suppressed
symbol blinks. Pressing the SET button now toggles
the units of measure between mT-h and T-h
(milliTesla-hours and Tesla-hours).
Setting the Integrating Alarm Value
1. After you have set the alarm value unit of measure
for integrating measurement (see step 4, above),
press the SELECT button. The most significant digit
of the integrated alarm value blinks.
2. Each time the SET button is pressed, the value of
this digit increments by one (1). Press SET until the
selected digit indicates the desired value.
3. Each time you press SELECT button, the digit to be
programmed advances to the right. Proceed in this
manner, setting each individual digit, to set the exact
alarm value desired.
4. After you have programmed all digits of the alarm
value, pressing the SELECT button again returns the
instrument to the alarm ON/OFF state (see
"Activating/Deactivating the Alarm").
5. When you return to the alarm ON/OFF, the I B
AL-SET mark will go out and, as before, the leading
Archived 4/2/10