ETS-Lindgren HI-3550 Magnetic Field Monitor (Archived) - Manual (Page 18)

HI n 3550 Manual Page — 13
Figure 5
Integrated Time and Integrated Value Cleared
5.0 DESCRIPTION OF HI n n 3550 OPERATION
Introduction
This section provides a detailed description of the
operation of the HI n 3550.
Measurement Cycle
The HI n 3550 performs a measurement every three
seconds and displays the results on the lower line of the
display panel.
Measurement Ranges
The HI n 3550 can measure magnetic field strength up to
0.3 T for each of the three axes. Depending on the
orientation of each sensing axis with respect to the
direction of the magnetic field, it is possible to display the
measured value of field intensities greater than 0.3 T.
In the integrating mode, the HI n 3550 displays elapsed
time on the upper line of the display panel. "H" denotes
hours, "M" denotes minutes, and "S" denotes seconds.
Integrating time is displayed up to 999 hours, 59
minutes, 59 seconds. When elapsed time exceeds this
value, the display rolls over to 0 hours, 00 minutes, 00
seconds, and restarts the count.
Archived 4/2/10