ETS-Lindgren HI-2602 Interlock Monitor - Manual (Page 8)

8 | Introduction
The diode detection array of eight hot carrier diodes is housed in the large end of
the plastic probe. This antenna array has the unique ability to sum microwave
electric fields of any polarization in a plane perpendicular to the axis of the probe.
The probe is attached to the main unit by a BNC connector. The main unit and
the probe are calibrated as an integral unit. Temporary over-exposure of up to
2000 mW/cm² will not cause probe burn-out or damage to the instrument or its
calibration.
Standard Configuration
• HI-2602 main unit
• Probe cable assembly (including probe sensor cover)
• Amp plug and hood
• Amp pins, 9 pieces
• User manual
ETS-Lindgren Product Information Bulletin
See the ETS-Lindgren Product Information Bulletin included with your shipment
for the following:
• Warranty information
• Safety, regulatory, and other product marking information
• Steps to receive your shipment
• Steps to return a component for service
• ETS-Lindgren calibration service
• ETS-Lindgren contact information