ETS-Lindgren HI-2602 Interlock Monitor - Manual (Page 14)

14 | Assembly and Installation
Locate and mount the sensing probe to the Probe Connection port. Caution must
be taken when using metal probe mounts as metal materials close to the sensing
end of the probe may cause inaccurate readings. Direct air flow from heating and
air conditioning vents may also cause erroneous readings.
Route the probe cable so that the probe may be adjusted without placing stress
on the probe to cable connections.
Connect a suitable alarm indicator to the output connector. Check the label
above the connector to ensure the output specifications are not exceeded. Also,
check to ensure the pin numbers of your cable match the pin numbers of the
output connector.