ETS-Lindgren 4340 CCTV Systems - Manual (Page 9)

Introduction | 9
The standard configuration for the Model 4340 CCTV includes these
components:
 Panasonic Network Camera WV-SC385 —Includes Ethernet cable
and power cable connected to camera.
 Shielded camera enclosure with dome —Includes camera
penetration connected to enclosure, and absorber wrap for the
enclosure.
 Mounting hardware —The hardware allows you to mount the camera
enclosure from the wall or ceiling, and includes two 12-inch pipe
lengths, one 6-inch pipe length, one elbow joint (for wall mount only),
four pipe-to-pipe couplers, and absorber wrap for the assembled pipe.
 10/100 Ethernet Filter —Provides one Ethernet connector, two
fiber optic connectors, an Ethernet-to-fiber optic converter, and a
fiber optic to Ethernet converter. Depending on your configuration, the
fiber optic to Ethernet converter may be provided as an internal or
external converter. Following are the two types of 10/100 Ethernet
filters:
– LMF-4095 10/100 Ethernet filter—Includes internal
fiber optic-to-Ethernet converter.
– LMF-4106 10/100 Ethernet filter—Includes external
fiber optic-to-Ethernet converter.
 Personal Computer —Includes monitor, mouse, and keyboard.
 10/100 Network Switch —If you ordered a multi-camera configuration,
you will install the 10/100 network switch. If you ordered a
single-camera configuration, you will not install the switch. In that case,
store the 10/100 network switch in a safe location for future expansion
of your Model 4340 CCTV.
A 30-meter Ethernet cable is included with some configurations.