beautypg.com

Section 37 - back panel insulation installation – EFCO 8800 Series Assembly Instructions Vol.6 User Manual

Page 14

background image

EFCO 2009

Page 14

Series 8700 / 8800 Unitized Curtain Wall Assembly Instructions - Volume 6

Figure 31

Impaling Pin

Apply pins into the

sealant or adhesive

Figure 32

Tool sealant

or adhesive

Figure 30

Impaling Pin

Figure 29

Section 37 - Back Panel Insulation Installation

1. Clean the panel and impaling pin surfaces that will contact sealant (or adhesive) with an approved solvent or cleaner.
2. Apply adhesive or sealant to the surface of the panel in a pattern per the manufacture’s recommendations. See Figure 29.
3. Apply impaling pins into the adhesive or sealant forcing the material through the holes in the base of the impaling pin. See Figure 31.
4. Tool the adhesive or sealant over the impaling pin base, and smooth it onto the panel. See Figure 32.

Apply sealant or adhesive in a
pattern as recommended by the
impaling pin manufacturer.

Adhesive

Impaling Pins

Galvanized Steel

Back Panel

This manual is related to the following products: