Dyras BQ-1500 - Manual (Page 9)

EN
BQ-1500
9
3. Place the heating unit into the cavity of the pan in a way so that the support bars of the heating wire fit into
the bore-holes of the pan.
4. Finally, place the grill grid on the appliance. You can adjust 2 heights depending on which bore holes or
depression you use to fit the grid into.
Using of appliance
1. Fill the grill pan with cold tap water until the marking “MAX” on its internal surface. When filling water, pay
special attention to prevent waterdrops from contacting the heating element. When using the appliance,
always monitor the level of filled in water and if it gets under the “MIN” level, add water. If you operate
the grill with too little water, your appliance may get damaged or it may become overheated. If you have
to supplement the evaporated water level, always disconnect the network plug of the appliance from the
wall socket or extension cable first. When filling in water, prevent water from getting onto the hot heating
element.
2. When you finished water filling, adjust the thermostat to minimum position and connect the appliance to the
network. Set the thermostat to the desired position. Red light indicates when the thermostat is on.
3. When the device is first used, the new grill may emit a slight odour, which soon dissipates. After this, the
barbecue grill is ready to use. The heating element heats up to cooking temperature 6 to 8 minutes after
connection to the power supply.
4. Put the food to be grilled, directly onto the grill grid. Don’t put the food on plates, trays, alu-foils or other
objects.
5. If you wish to finish its use, turn off the appliance by turning the thermostat to minimum position, then
remove the network connector from the wall plug.
MAINTENANCE AND CLEANING
Warning! Before you clean the appliance it must be switched off and the mains plug must be
removed from the wall socket.
Before starting cleaning, wait until the barbecue grill has completely cooled down. Only then,
remove the cover and start cleaning.
It is very important not to place the heating unit in water and you must never hold it under a
water jet.
1. Once the barbecue grill has been unplugged and cooled down, lift the grill grid and remove the heating unit
from the grill tub. Pour out waste water from the grill tub. Clean both the grill grid and the grill tub with a
slightly damp, smooth, fibre-free cloth or soft cleaning or rinsing agent. Now wipe the clean surfaces dry with
a dry, fibre-free cloth. Before using again, let the appliance completely dry out.