Dyras BQ-1500 - Manual (Page 5)

EN
BQ-1500
5
EN
5
• The mains connector must be always disconnected from the wall socket after use and before cleaning.
Never disconnect the appliance from the socket by pulling the mains cable; always grip the plug!
Dear Customer,
All electrical and mechanical equipment needs to be cared for appropriately. It’s important to
note that using or storing the appliance in certain conditions may adversely affect its lifespan and
functionality. Always protect the appliance from the conditions listed below.
Using or storing the appliance in a wet, humid or damp environment can cause:
- deterioration and premature aging of the cover and electric insulation of the appliance,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause:
- greasy dust coatings on the mechanical and electrical elements and the casing of the appliance,
which could result in electrical contact failure or even complete breakdown, and could also
damage the plastic and rubber elements.
The effects of direct sunlight on the appliance can include:
- accelerated deterioration of the appliance casing and its plastic and rubber components,
damage to strength and other structural features. The appliance’s surface may become porous
and fragile, which may result in a safety risk.
Storing the appliance in cold or frosty environment may cause:
- damage to the plastic and rubber components; if they become fragile, this may result
in a safety risk.
- oxidation resulting from condensation, and corrosion of the metal components.
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:
- damage, deformation, softening or melting of plastic or rubber parts and casing elements, or
deterioration of electrical insulation.
Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. You are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.
• Warning! Unplug the appliance from the plug when not in use. Before unplugging the power cable, switch
off the appliance then pull out the power cable from the wall (or extension) socket.
• The device must have sufficient time to cool down before removing or re-inserting its components, or before
cleaning.