Dynojet Scooter Dyno SD-12 Installation Guide - Manual (Page 14)

Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 1
Dynamometer Specifications and Requirements
1-6
C OMPRESSED A IR R EQUIREMENTS
The following requirements are needed for optional compressed air pump assembly:
• Clean and dry air, 100 psi or greater, 5 CFM or better flow
• Fittings to hook your air system to a 3/8-inch inside diameter hose (if no air brake is
present)
• optional air regulator
C OMPUTER S PECIFICATIONS
You will need to provide a computer system to run the WinPEP software. WinPEP 7
includes complete documentation in online Help. From the WinPEP 7 menu bar,
choose Help
 WinPEP 7 Help or visit www.winpep.com (accessible with a valid user
name and password). Refer to the section on Computer Specifications in the WinPEP
documentation, P/N 98118103, for the specific computer system requirements.
E NVIRONMENTAL R EQUIREMENTS
F ORKLIFT R EQUIREMENTS
You will need to provide equipment capable of lifting a minimum of 454 kg.
(1000 lb.) to lift and move the crated dyno.
You will need to provide a 5/8-inch x 3-foot steel bar to lift the drum off the crate.
P HONE AND I NTERNET A CCESS
Dynojet recommends you have a phone close to the dyno to call for assistance in an
emergency. You may also wish to contact Dynojet to troubleshoot your dyno.
Internet access on your computer is desirable for contacting Dynojet and
downloading new information and updates.
T IE -D OWN S TRAPS
Dynojet recommends using motorcycle tie-down straps for securing the bike on the
dyno. You will need to provide the tie-down straps.
description specifications
Temperature
operating min./max 10°C/50°C (50°F/122°F)
storage min./max 0°C/60°C (32°F/140°F)
Humidity 0 to 95% non condensing