Dynojet Data Link Module - HD Delphi ECM - Manual (Page 8)

Data Link Module - HD Delphi ECM Installation and User Guide
D A T A L I N K M O D U L E - H D D E L P H I E C M
DJ-DLM Set Up
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DJ-DLM SET UP
This section provides basic instructions for setting up the DJ-DLM with WinPEP 7. To
ensure safety and accuracy, perform the procedures as they are described.
I NSTALLING THE DJ-DLM
1 Connect the Data Link Module to the bike’s data port.
2 Connect the USB connector from the Data Link Module to the USB port of the
computer where you are running the WinPEP software.
3 Turn the motorcycle’s key to the ON position. If you have a “ready to start” switch
make sure it is in the ON position.
Figure 1: Connect the DJ-DLM to the Bike’s Data Port and to Your Computer’s USB Port
66114004 HD Delphi ECM - Data Link Module
Stock Code Description Quantity
42970052 Cable, USB A to Mini-B, 15ft 1
59930004 H-D Data Link Module 1
98100002 H-D Delphi ECM - DLM Installation/User Guide 1
connect to bike’s
data port
connect USB cable
between DJ-DLM and
computer