Dynojet Data Link Module - HD Delphi ECM User Manual

Page 11

D A T A L I N K M O D U L E - H D D E L P H I E C M

DJ-DLM Set Up

Version 1

Data Link Module - HD Delphi ECM Installation and User Guide

ROUBLESHOOTING

ONNECTION

RRORS

If you do not see the Device Connected - Communicating with the ECU, check to see
that you are not experiencing one of the following problems:

If you still cannot establish connection between your DJ-DLM so that it is
communicating between the software and the bike’s ECU, call Dynojet Technical
Support at 1-800-992-3525 for personal assistance.

Problem

TRY THIS

THEN THIS

Device Not

Connected

Verify that USB cable is

plugged into computer

and is making

connection.

Verify the DJ-DLM is plugged

into the bike’s data port. This

occasionally may appear to

“snap” into place, but may not

be making connection.

Error

Communicating

with ECU

Verify that bike power is

turned on and if there is a

ready to start switch it is

turned on. If necessary

start the bike.

Recheck the plug end to the

bike’s data port. This

occasionally may appear to

“snap” into place, but may not

be making connection.