DSS Networks C5468 - Manual (Page 20)

GigMAC-CPCI-3U Network Interface Cards
Gig-CPCI-3U Gigabit Ethernet Switches
Board and Driver Users Manual
DSS NETWORKS, INC. DocVersion: 1.2 Page: 20
RJ-45 pinouts for CAT5 connectors and cables are shown in the following table:
Pin 10/100 Signal Gigabit Signal
1 Transmit+
Channel A+
2 Transmit- Channel A-
3 Receive+ Channel B+
4 Unused Channel C+
5 Unused Channel C-
6 Receive- Channel B-
7 Unused Channel D+
8 Unused Channel D+
10. SOFTWARE DRIVER INSTALLATION
The following sections explain how to install the driver software in VxWorks, and Linux
based systems.
10.1 LINUX DRIVER INSTALLATION AND USAGE
These instructions assume that you are running Red Hat Linux 7.x, 8.x, 9.x or a similar
Linux OS. You should be using at least a kernel version 2.4.18 installation for any other
Red Hat-based system will be similar. For other Linux based systems, the location of
some files may be slightly different.
Building the driver
To build the driver, copy the driver files to an appropriate directory. You will need to
make sure your CD is mounted.
$ mkdir dpm
$ cd dpm
$ cp /mnt/cdrom/linux-dpm-driver/dpm/dpm*.tar.gz .
$ gunzip dpm*.tar.gz
$ tar vxf dpm*.tar
To create a new driver object module:
$ make clean
$ make
Repeat same procedure with driver utility directory as follows: