DSS Networks C5468 - Manual (Page 17)

GigMAC-CPCI-3U Network Interface Cards
Gig-CPCI-3U Gigabit Ethernet Switches
Board and Driver Users Manual
DSS NETWORKS, INC. DocVersion: 1.2 Page: 17
6.7 ETHERNET FRAME LATENCY
The following table shows typical system level frame latencies measured during high-
performance testing using frame generator including path from SDRAM to wire through
system controller across PCI bus interface:
Frame size (bytes)
Typical latency
(microseconds)
60 – 100 < 2
500 4
1000 8
1500 12
7. POWER CONSUMPTION SPECS
3U CPCI Boards Power Consumption Table
Card Model
3.3V Source
Current I (mA, A)
Power (Watts)
C5261 900 2.97
C5262 1.17 3.86
C5263 1.17 3.86
C5164 2.34 7.90
C5264 2.34 (est) 7.90 (est)
C5468 1.93 6.40
8. HARDWARE INSTALLATION
Before attempting to install the card into your system, please make sure of the following:
Shut off the power to the computer and any peripherals. It is important to remove the
power cable to the computer to reduce the possibility of residual power remaining in
the power supply.
Ground yourself. Many electronic components inside computer and on the card can be
severely damaged by receiving a shock of static electricity. Before touching any
electronic components or boards, discharge any static electricity on your body by
touching the bare metal case around the power supply inside your computer. Avoid
excessive movement during the installation, such as walking across carpets, as this can
generate static. If you must leave the installation area before the installation is
complete, be sure to ground yourself again before continuing the installation.