Dave Smith Instruments MOPHO X4 - Manual (Page 21)

15
Mixer
The Mixer section balances the levels of the outputs of the Oscillators section
and noise generator, and the Audio In/feedback loop before routing the summed
signals to the low-pass filter.
Mix: 0...127 —Mixes the outputs of oscillators 1 and 2 in varying amounts. A
setting of 0 is equivalent to 100% oscillator 1 and 0% oscillator 2. A setting of
127 is just the opposite. A setting of 64 is a 50/50 mix of both oscillators.
Feedback Amount: 0...127— Increasing F
EEDBACK
A
MOUNT
causes more and
more of each voice’s left output signal to be fed back into the audio path pre-
filter. As the level increases, so does the effect of the feedback.
Feedback Gain: 0...127
—F
EEDBACK
G
AIN
boosts the level of the feedback
signal and is interactive with and dependent upon F
EEDBACK
A
MOUNT
. If
F
EEDBACK
A
MOUNT
is set to 0, then F
EEDBACK
G
AIN
has no effect. (There is no
feedback signal to boost.) However, F
EEDBACK
G
AIN
combined with higher
levels of F
EEDBACK
A
MOUNT
can result in effects ranging from pleasing
distortion to squirrelly harmonic weirdness.
Noise: 0...127
—Controls the volume of the white noise generator.