Dave Smith Instruments MOPHO X4 User Manual

Page 16

Jump mode uses an absolute value based upon the position of the pot when

edited: turn a pot and the value jumps immediately from the stored value to the

edited value.

Sustain: Norm +, Norm -, Arp +, Arp

- —A momentary footswitch connected to

Mopho x4’s Sustain input can be used either as a sustain pedal or to latch the

arpeggiator. Mopho x4 can be configured for use with either normally open (+)

or normally closed (-) footswitches. When set to Arp+ or Arp-, the footswitch

will act as a sustain pedal when the Arpeggiator is off.

Pedal: see table—

Sets the destination for the Pedal/CV input. Note that this

input is heavily filtered for clean operation, so there is a limit to the speed it will

respond to changes.

Display Pedal Routing

FootCtrl

Routed to the Foot Control Modulation

Breath

Routed to the Breath Control Modulation

Expressn Routed to the Expression Modulation

Volume

Controls Master Volume

LpFilter

Routed to the low-pass filter

LpF Half Routed to the low-pass filter, but with half the range

The input will also accept control voltages in the range of 0 to 3.3 volts DC. It is

protected against higher or negative voltages.

MIDI Pressure: Off, On—

When On, the Mopho x4 will respond to received

MIDI pressure (aftertouch) messages and will transmit pressure from the

keyboard to MIDI Out.

Pressure Curve: 1…4—

Sets one of the four pressure curves for the keyboard to

adjust the aftertouch to your playing style.

Velocity Curve: 1…4—

Sets one of the four velocity curves for the keyboard to

adjust the velocity response to your playing style.

ArpLatch: Normal, ReLatch—

Sets the arpeggiator latch behavior. See

Arpeggiator on page 27 for more information.

Basic Patch—

Press the W

RITE

button to load a basic patch into the edit buffer.

The patch will not actually be written to the current program location unless

intentionally written to memory in program mode using the W

RITE

button.

Reset Globals—

Select this parameter and press W

RITE

to reset the global

parameters to their factory defaults.