Coral Industries Provincial Prestige Neo-Angle Swing Door - 846J - Manual (Page 4)

846J 10/02
Slide magnetic strip (H) into slot on magnetic door
stop (G). Trim ends even with door stop using
scissors.
Decide which will be the opening side of your door.
Door is normally installed to open on the side of unit
nearest to the showerhead. For safety purposes, door
should be installed to open out from shower.
Slide magnetic door stop into corner post on opening
side of door with magnetic strip facing outside of
shower.
Position hinge door stop, which is attached to door
panel, into opposite corner post.
Male
Corner
Post
Magnetic
Strip
Sill
H
OUTSIDE OF SHOWER
OUTSIDE OF SHOWER
Place side panel into wall jamb with bottom of panel
resting on sill.
Slide male corner post (E) onto side panel. Position
female corner post (F) against male post with closed
curve of female post fitting against curve of male post.
6
On units with clear, painted glass,
the painted surface of glass faces
outside of shower.
On units with tinted, painted glass,
the painted surface of glass faces
inside of shower.
Male
Corner
Post
E
Side
Panel
Sill
A
8 If magnetic strips do not seal tightly, reverse polarity by removing strip from door stop and replacing it
with the previous top end as the bottom end.
Magnetic
Door Stop
Door Panel
with Hinge
Door Stop
Side
Panel
Side
Panel
7
OUTSIDE OF SHOWER
Sill
A
Female
Corner
Post
F
Male
Corner
Post
Side
Panel
Female
Corner
Post
F
E
8A x 3/8"
Truss Head
Screw
L
E
Female
Corner
Post
F
Male
Corner
Post
E
Female
Corner
Post
F
G
A
Jamb
B
Adjust side panel and corner posts so that posts fit into
corner of sill securely and are flush against tall edge of
sill.
Align posts vertically using a level. Secure posts
together by drilling three evenly spaced holes through
center of female post into male post. Secure using
8A x 3/8" truss head screws (L).
Repeat for panel and posts on opposite side.