Coral Industries 6000 Pivot Door - 7631 - Manual (Page 4)

7631 / 7131-GP 9/06
OUTSIDE
OF SHOWER
Measure opening at threshold of shower and cut sill (A)
to that measurement. If necessary for a smooth fit, file
sharp corners of sill to fit contour of your unit.
Measure
Position sill on center of threshold with tall edge of sill
toward outside of shower.
Tape sill to threshold with masking tape to hold in place
while positioning jambs.
Threshold
Centerline
Masking Tape Sill
A
OUTSIDE OF
SHOWER
Pivot Plate
INSIDE OF SHOWER
If necessary, file sharp
corners of sill to fit contour
of unit.
8A x 3/8" Pan Head
Self-Drilling Screws
Pivot
Vinyl
L
K
P
B
Pivot
Jamb
Sill
A
Decide which will be the opening side of your door. Door
is normally installed to open on the showerhead side of
unit. Pivot jamb (B) will be mounted on wall opposite
from opening side.
Before placing pivot jamb against wall, bottom pivot
plate (L) will be mounted onto bottom of pivot jamb.
Trim bottom of pivot door vinyl (K) so that pivot plate will
fit flush against pivot jamb. Slide pivot plate into bottom
of pivot jamb. Secure using 8A x 3/8" and 8A x 5/8”
pan head self-drilling screw (P, S) as shown in
illustration.
(Mount only bottom pivot plate at this time. Top plate will
be mounted later in installation.)
Trim pivot vinyl
Due to the manufacturing process, there may be
rack marks present at one end of your sill. Sill
must be trimmed to fit your individual opening.
When cutting sill, make certain to trim off end
with rack marks.
1 Sill
(A)
2 Sill
(A)
3 Pivot Jamb
(B)
/ Pivot Plate
(L)
8A x 5/8" Pan Head
Self-Drilling Screws S