Code 3 Warrior - Manual (Page 4)

4
Wiring Instructions
All models are stand alone self-contained units ready for installation with no special wiring required. They are
provided with a cigarette plug designed to be used with a +12VDC fused lighter socket.
Alternately, the user can remove the plug and connect (through a properly sized fuse) to a user supplied switch.
The ribbed wire is positive (+12VDC) and the smooth wire is negative.
Operation
The LED lightheads arrive completely assembled and ready for installation. They are designed to
function at 10 - 16 VDC.
To operate the unit, insert the cigarette plug provided into a +12VDC lighter socket and
rotate 1/4 turn to insure a good electrical connection.
Flash Patterns Selections
Each of these modes can be selected by using the momentary button located on the unit. Each flash mode can
be selected by momentarily depressing the button until the unit stops flashing, and then releasing. As each
flash mode is selected it is automatically programmed into the unit such that when power is removed it will
always return to the selected mode the next time power is applied. If another mode is desired, just use the
momentary button to step through each mode until the desired mode is found.
Selecting and programming Cycle Flash mode in the Warrior™ models:
When shipped, the unit will be in “Cycle Flash mode”. This mode cycles through a variety of flash patterns
continuously providing an ever changing warning signal. If the unit is not in Cycle Flash, or you wish to return to
Cycle flash from another mode, then the momentary button should be depressed until the unit stops flashing,
and held on for several seconds then released. This will program cycle flash into the unit.
6-Up Head Model
Flash Modes:
Alternating Heads Simultaneous Heads Steady with Flashing
Cycle Flash Quad Flash Fast Double Flash w/Steady
Single Flash Triple Flash Quad Flash w/Steady
Double Flash Double Flash
Triple Flash Single Flash
Quad Flash Pursuit Flash
Five Flash
Fast Single Flash
Fast Double Flash
Fast Triple Flash
Fast Quad Flash
Quad Pop Flash
Triple Pop Flash
Double Pop Flash
Wig-Wag Flash Alt.
Note: All modes flash at a rate of 70 fpm minimum. Fast modes flash at a rate of 100 fpm minimum.
Warrior 3-Up OPTIX Model
Flash Mode:
Cycleflash (Factory default)
Steady Burn
Five Flash
Quadflash
Triple Flash
Doubleflash
Fast Double Flash
NFPA
Quad Pop Flash
Triple Pop Flash
Gladiator™ LCLED™ Model
Flash Mode:
Steady Burn
75 FPM Single
75 FPM Double Flash
75 FPM Quad
Cycle