Code 3 Volt User Manual
Page 3

Manufacturer Limited Warranty and Limitation of Liability:
Manufacturer warrants that on the date of purchase this product will conform to Manufacturer’s specifications for this product (which are available from the
Manufacturer upon request), and Manufacturer further warrants that this product is free from defects in materials and workmanship. This Limited Warranty
extends for twenty-four (24) months from the date of purchase. Other warranties may apply, call Manufacturer for details. Manufacturer will, at its discretion,
repair or replace any product found by the Manufacturer to be defective and subject to this Limited Warranty.
DAMAGE TO PARTS OR PRODUCTS RESULTING FROM TAMPERING, ACCIDENT, ABUSE, MISUSE, NEGLIGENCE, UNAPPROVED MODIFICATIONS,
FIRE OR OTHER HAZARD; IMPROPER INSTALLATION OR OPERATION; OR NOT BEING MAINTAINED IN ACCORDANCE WITH THE MAINTENANCE
PROCEDURES SET FORTH IN MANUFACTURER’S INSTALLATION AND OPERATING INSTRUCTIONS VOIDS THIS LIMITED WARRANTY.
ORAL STATEMENTS OR REPRESENTATIONS ABOUT THE PRODUCT WHICH MAY HAVE BEEN MADE BY SALESPEOPLE, DEALERS, AGENTS OR
OTHER MANUFACTURER’S REPRESENTATIVES DO NOT CONSTITUTE WARRANTIES. THIS LIMITED WARRANTY MAY NOT BE AMENDED, MODI-
FIED, OR ENLARGED EXCEPT BY A WRITTEN AGREEMENT SIGNED BY AN AUTHORIZED OFFICIAL OF MANUFACTURER WHICH EXPRESSLY
REFERS TO THIS LIMITED WARRANTY.
Exclusion of Other Warranties:
MANUFACTURER MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED. THE IMPLIED WARRANTIES FOR MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE ARE HEREBY EXCLUDED AND SHALL NOT APPLY TO THE PRODUCT. BUYER’S SOLE AND EXCLUSIVE REMEDY
IN CONTRACT, TORT, OR UNDER ANY OTHER THEORY AGAINST MANUFACTURER REGARDING THE PRODUCT AND ITS USE SHALL BE THE
REPLACEMENT OR REPAIR OF THE PRODUCT AS DESCRIBED ABOVE.
Limitation of Liability:
IN THE EVENT OF LIABILITY FOR DAMAGES ARISING OUT OF THIS LIMITED WARRANTY OR ANY OTHER CLAIM RELATED TO THE MANUFAC-
TURER’S PRODUCTS, MANUFACTURER’S LIABILITY FOR DAMAGES SHALL BE LIMITED TO THE AMOUNT PAID FOR THE PRODUCT AT THE TIME
OF THE ORIGINAL PURCHASE. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR LOST PROFITS, THE COST OF SUBSTITUTE EQUIPMENT
OR LABOR, PROPERTY DAMAGE, OR OTHER SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES BASED UPON ANY CLAIM FOR BREACH OF
CONTRACT, IMPROPER INSTALLATION, NEGLIGENCE, OR OTHER CLAIM, EVEN IF MANUFACTURER OR A MANUFACTURER’S REPRESENTATIVE
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. MANUFACTURER SHALL HAVE NO FURTHER OBLIGATION OR LIABILITY WITH
RESPECT TO THE PRODUCT OR ITS SALE, OPERATION AND USE, AND MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES THE ASSUMP-
TION OF ANY OTHER OBLIGATION OR LIABILITY IN CONNECTION WITH SUCH PRODUCT.
This Limited Warranty defines specific legal rights. You may have other legal rights which vary from state to state. Some states do not allow the exclusion or
limitation of incidental or consequential damages.
#
Pattern:
Frequency: Description:
1
Quad Flash
1.25 Hz
75 Quad Flashes Per Minute
2
Double Flash
1.25 Hz
75 Double Flashes Per Minute
3
Triple Flash
1.53 Hz
92.3 Triple Flashes Per Minute
4
DeciBlast
1.42 Hz
85.5 Deci Flashes Per Minute
5
Single Flash
1.25 Hz
75 Single Flashes Per Minute
6
Mega Flash
1.90 Hz
114 Single Flashes Per Minute
7
Triple+Burst
1.37 Hz
82.5 Triple+Burst Flashes Per Minute
8
Steady On
Steady On
9
Cycle All
Cycle through patterns 1 to 7
10 Double-Triple+Burst
2 Double, 2 Triple+Burst cycle
11 Cycle Classic
1 Double, 1 Quad, 2 Mega cycle
12 Quad-Mega
3 Quad, 4 Mega cycle
13 Single-Quad
2 Single, 2 Quad cycle
14 DeciBlast-Quad
2 DeciBlast, 2 Quad cycle
15 Single-Triple-DeciBlast
2 Single, 2 Triple, 2 DeciBlast cycle
16 Mega-Triple+Burst
1 Mega, 1 Triple+Burst cycle.
920-0211-00 Rev. A
Page 3 of 3
HEAD NOT FLASHING:
Check the RED and BLACK wires for a reversed connection.
(Reverse connection will not damage the unit).
Check RED and BLACK wires for either a bad splice or a corroded
ground connection.
HEADS NOT SYNCHRONIZING:
Check for a short circuit on the BLUE wire to either +V or GROUND.
Salt water on the wire connections will short circuit the sync signal on
the BLUE wire. Check for non-functional heads in the system. If any
one of the heads has a bad GROUND connection it can cause the
sync signal to become corrupted. If any one of the heads has it’s RED
and BLACK wires reverse connected it will corrupt the sync signal.
FLASH PATTERN CHANGING:
If the flash pattern changes on it’s own there may be an intermittent
short between the BLUE wire and +V. Check for water in the wiring
connections. If any one of the heads in the system has an intermittent
GROUND connection it can also cause the flash pattern to change.
TroubleShooting:
833 West Diamond St
Boise, Idaho 83705
Customer Service
USA 888-844-6682
www.novawarning.com